Raimondi

RAIMONDI | RLS Levelling System Base Clips - Small (3-12mm) - 1mm

$21.95 inc GST
  |  

Raimondi Levelling System Base Clips - Small (3-12mm)

Code: RAI-LSBC1MM

  • Minimum joint width 1mm
  • Small Clips - Tile thickness 3 - 12mm
  • Various quantities available
  • Use with RAI-LSW
Code Description
RAI-LSBC1MM100 Raimondi Levelling System Base Clips - Small (3-12mm) - 100 pcs
RAI-LSBC1MM250 Raimondi Levelling System Base Clips - Small (3-12mm) - 250 pcs
RAI-LSBC1MM500 Raimondi Levelling System Base Clips - Small (3-12mm) - 500 pcs
RAI-LSBC1MM3000 Raimondi Levelling System Base Clips - Small (3-12mm) - 3000 pcs

 

Correct setting requires the perfect levelling of the tiles.

Very often it is hard to properly set flexible and low thickness tiles as well as big sized and heavy tiles because of the uneven floor foundation. As a result, tiles which seemed perfectly levelled while installing them, once the adhesive has set, they show differences in level that compromise the aesthetics.

This can be avoided thanks to the levelling spacers which preserve the perfect levelling of the tiles and, also, they speed up the setting. So, the levelling spacers make the setting easy, fast and the tiles are perfectly levelled.

Clips are available in two different versions: for tiles from 3 up to 12 mm thickness (1/8” - 1/2”); LARGE size clips for tiles from 12 up to 20 mm thickness (1/2” - 3/4”). The wedge works for both clip sizes and it is re-usable virtually forever.

Both the positioning and the removal of the levelling spacers is easy and quick.

HOW TO USE:
How to set the support:
  1. After having spread the adhesive, insert the support underneath the tiles and along the 4 sides.
  2. According with tiles size, set one or more supports on every side of the tile.
  3. Set the tile and beat it with a rubber mallet.
How to insert the wedge:
  1. Insert the wedge in the support slot paying attention not to pass the breakpoint.
  2. To facilitate this operation, the use of the special traction-adjustable-pliers is recommended.
How to remove the support:
Once the adhesive is set, the protruding part of the support, has to be removed by separating it from the base. This can be done thanks to the traction-adjustable-pliers, with a rubber mallet or even with feet. Beat parallel to the joint.
 
© Stonex - All Rights Reserved